Cabinets
Cabinet painting
Most kitchen remodels in Clovis and Sanger start with cabinets that are structurally fine and visually tired. We refinish them so they look built-in, not slapped with a roller.
Cabinet work is a finishing trade, not a wall-paint side job. Doors come off. We clean grease, sand, prime with a bonding primer, and spray for a factory-smooth film.
You keep using the kitchen with a plan — we work in phases so you are not eating out of boxes for two weeks unless the scope says otherwise.
On a typical job
- Kitchen and bath cabinets
- Degloss, sand, and bonding primer
- Sprayed enamel-quality finish
- Doors labeled and rehung true
Best for
- Oak kitchens going light
- Builder-grade cabinet refresh
- Bathroom vanities
- Color-matched islands
How we work
- 01
Walk the house
Jorge or a lead walks the property with you. We look at sun exposure, peeling, moisture, and the colors you actually want to live with — then send a written estimate.
- 02
Prep like it matters
Power wash, scrape, sand, patch, caulk, and prime. Valley dust and pollen get cleaned off, not painted over. Furniture and floors are covered. Hardware comes off and gets labeled.
- 03
Coat for this climate
Sherwin-Williams Duration, Emerald Rain Refresh, SuperPaint, and Benjamin Moore Aura — UV-resistant, low-VOC when you want it. Two coats. Crisp cut-in. Timed around Fresno heat.
- 04
Leave it livable
We walk the job with you, touch what needs touching, and leave the place cleaner than we found it. No mystery paint cans in the garage unless you ask to keep extras.
Related services
CSLB 1036625 · Clovis, CA
Ready to walk the house?
Free on-site estimates across Fresno County. Tell us the rooms, the sun, and the color you keep circling.